The Rapier Looms Are On The Machine Again

Sep 19, 2019

Leave a message

1. The machine on the back of the machine is actually a maintenance. First of all, we must do a good job of cleaning the whole machine. The main parts of the whole machine are fully refueled, especially those that cannot be added during work. Also check the tightening degree of the screw once in the whole machine to check whether some specifications are out of shape and whether the various gaps are changed.

2. If the variety is changed, the position of the temple and the time of entering and leaving the sword should be adjusted according to different wearing widths. Pay special attention to the opening and the time of entering and leaving the sword.

3. Take the Model 180 as an example. When the width is 1700mm, the weft scissors should be placed in the third gear of the track piece. When the frame width is 1600mm, the scissors should be placed on the track piece, the fourth and fifth gears. When the width is about 1500mm, the scissors should be placed on the sixth gear of the track piece.