1. After the new transmission box has been in operation for 3 months, it must be disassembled for inspection. The gear clearance should be adjusted. The adjustment method is as follows:
Remove the thin copper piece from the seam, adjust it so that the rotation is flexible, and change the oil at the same time. Because this running time is, the new gear has powder appearing during the operation, and the semi-flow oil will be ground together and directly invaded. The gear itself is reassembled after being cleaned with diesel oil, which can extend the service life of the machine and also change the angle of the gear. Generally, it should be changed once every 3 months by 90° angle, 4 times a year, which can greatly extend the machine parts. The service life.
2. Scissors, side shears, and edging devices should be regularly maintained. Always check whether the bearings in the small eccentricity are short of oil. The eccentric shaft below the sector plate loses oil. The copper sleeve in the large belt plate cannot be short of oil.