1. The steel ball weft scissors 1mm ~ 2mm, this benchmark should be fixed, greater than this distance will affect the weft into the scissors, causing weft break, and waste weft yarn, less than this distance, steel smash and scissors will collide, in addition, The steel strip below should be well padded.
2. Tightening the screw is best for one person to the end. If two people are tight, they must be separated from the center and tightened to the sides.
3. The machine should be knotted by one person, the warp yarn strength should be uniform, and the breakage should be less.
4. Check the teeth of the warp beam and tighten the screws.
5. The menstruation film can not be messed up, and must be flexible.
6. After weaving a piece of cloth, we must cut off the knot of the warp yarn and let it pass the guide stick smoothly.
7. Check the tension of the waste side yarn and the strength of the stranded yarn.
8. When adjusting the machine, adjust the winding weft teeth, and take a few teeth to see if it is too slippery.
9. Every time you weave a piece of cloth, check the cloth surface. You can't let the bad cloth weave down. At the same time, you can find out the length of the waste side yarn, the length of the edge of the cloth edge, and whether the twisted edge is good.