1. Open the main water supply pipe before starting the machine, first drain the water to prevent the residual sewage in the pipe from entering the water tank, pump body and nozzle.
2. Wet the warp of the weaving mouth and the steel shovel and the heald with water, and soften the remaining accumulated slurry to avoid pulling and breaking the warp residue after the direct driving.
3. Turn on the power, plug in the line control board, open the water supply valve of the water tank, test the power supply, pass the water, and observe whether the water and electricity are normal.
4. Adjust the warp tension and turn the spindle dial by hand to see if the spray, beating, and lifting are normal.
5. If it is necessary to change the variety and specifications of the blank, it is possible to change the weft and the appropriate weft and take-up gear to change the weft density.
6. If the steel shovel is severely slurried at the heald, causing warping of the warp yarn, etc., the warp yarn can be manually shaken through the woven mouth by a few centimeters to a dozen centimeters, and then try to drive according to the specific situation.
7. If the above main work is done well, after checking everything is normal, you can start the operation according to the normal program.
