Efforts to improve the output and operating performance of rapier looms, improve weaving efficiency and product quality are the goals of machine manufacturers to participate in world competition. If the total number of warp roots is large, it is recommended to increase the number of heald frames, which can effectively prevent the breakage rate. So the things to keep in mind at this time are:
1. The distance between the reed and the weft scissors is 1mm to 2mm. This reference should be set well. If the distance is greater than this, it will affect the weft entering the scissors, resulting in weft breakage and waste of weft. If the distance is smaller than this distance, the reed and the scissors will collide. In addition, the reed will collide with the scissors. The steel strips below should be well padded.
2. Tighten the screw to the end by one person. If two people are tight, separate them from the middle and tighten them to both sides at the same time.
3. One person should tie the knot on the machine, the warp tension should be uniform, and the broken ends should be less.
4. Check the teeth of the warp beam and tighten the screws.
5. Menopause cannot be messed up and must be flexible.
6. After weaving a piece of cloth, cut off the knot of the warp yarn to let it pass through the cloth guide rod smoothly.
7. Check the tension of the waste yarn and the tension of the skein yarn.
8. When the machine is on, adjust the weft density of the coiling teeth, and see if the coiling support teeth are too slippery.
9. Check the surface of the cloth every time you weave one meter of cloth. You can't let the bad cloth go down. At the same time, you can find out the length of the waste yarn, the length of the selvedge, and whether the skein is good.

